Instruction manual

7
www.evolutionpowertools.com
When fitted with a correct blade this
machine can be used to cut:
Wood
Wood derived products (MDF, Chipboard,
Plywood, Blockboard, Hardboard etc)
Aluminium
Mild Steel (6mm Ø)
NOTE: Wood containing non galvanised nails or
screws can, with care, can be safely cut.
PROHIBITED USE OF THIS POWER TOOL
WARNING: This product is a Multipurpose
Sliding Mitre Saw and must only be used as
such. It must not be modified in any way,
or used to power any other equipment or
drive any other accessories other than those
mentioned in this Instruction Manual.
WARNING: This product is not intended for use
by persons (including children) with reduced
physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they
have been given supervision or instruction
concerning the safe use of the product by a
person responsible for their safety and who is
competent in its safe use.
ELECTRICAL SAFETY
CONNECTION OF THE DOUBLE INSULATED
MAINS PLUG- UK ONLY
IMPORTANT: The wires in the mains lead fitted
to this product are coloured in accordance with
the following code:
Brown: Live (L) or Red
Blue: Neutral (N) or Black
THIS PRODUCT IS DOUBLE INSULATED
AND THEREFORE DOES NOT REQUIRE A
CONNECTION TO EARTH.
• THE 3 PIN PLUG MUST COMPLY TO
BS1363/A.
• THE FUSE MUST COMPLY TO BS1362.
If for any reason the 13 amp moulded plug
fitted to this product requires replacing, the
replacement must be wired in accordance with
the following instructions:
• Connect the Blue wire to the terminal
marked Neutral (N).
• Connect the Brown wire to the terminal
marked Live (L).
Ensure that the outer insulation is gripped by
the cord grip and that the wires are not trapped
when replacing the plug cover.
A 13 amp (BS1362) fuse must be fitted in the plug.
Do not connect any wire to the earth pin
MARKED E on the 3 pin plug.
If in any doubt consult a qualified electrician.
There are no user serviceable parts inside this
product except those referred to in the manual.
Always refer servicing to qualified service
personnel. Never remove any part of the casing
unless qualified to do so; this unit contains
dangerous voltages.
OUTDOOR USE
WARNING: For your protection if this tool is to
be used outdoors it should not be exposed to
rain, or used in damp locations. Do not place
the tool on damp surfaces. Use a clean, dry
workbench if available. For added protection
use a residual current device (R.C.D.) that will
interrupt the supply if the leakage current to
earth exceeds 30mA for 30ms. Always check
the operation of the residual current device
(R.C.D.) before using the machine.
