Instruction manual

29
www.evolutionpowertools.com
USE OF OPTIONAL EVOLUTION ACCESSORIES
Not supplied as original equipment. All accesories
can be purchased from Evolution Power Tools. See
‘Additional Accessories’ section.
DUST BAG
A Dust Bag can be fitted to the extraction port at the
rear of the machine. The Dust Bag is for use when
cutting wooden materials only.
• Slide the Dust Bag over the dust extraction port,
ensuring that the spring clip grips the port holding
the Dust Bag securely in place. (Fig. 40)
NOTE: For operational efficiency empty the Dust Bag
when it becomes 2/3 full. Dispose of the contents of
the Dust Bag in an environmentally responsible way. It
may be necessary to wear a dust mask when emptying
the Dust Bag.
NOTE: A workshop vacuum extraction machine can
be attached to the dust extraction port if required.
Follow the manufacturers instructions if such a
machine is fitted.
WARNING: Do not use the Dust Bag when cutting
metallic materials.
EXTRACTION PORT BLANKING PLUG
Use the blanking plug in place of the dust bag when
cutting steel based materials.
EXTRACTION PORT ADAPTOR TUBE
Use the Adaptor Tube to connect the extraction port
of the machine to suitable commercial workshop
vacum extraction equipment (not supplied) which have
Ø30mm internal bore hoses or inlet ports.
WORKPIECE SUPPORT BARS (Fig. 41)
Workpiece Support Bars can be fitted to either or both
sides of the machines base as required.
• Right Hand side. Loosen the support retaining screw
located in the top front of the machines base.
• Insert the workpiece supports bars into the
retaining holes in the base. Push fully home to
ensure positive location.
Fig. 41
Support Bars being fitted
Fig. 40
Dust Bag being fitted