Instruction manual

www.evolutionpowertools.com

Fig. 38

View of (1) Arbor screw, (2) Washer,

(3) Blade ﬂange, (4) Blade

• Press the black arbor lock button to lock the arbor.

(Fig. 37)

• Using the supplied Hex Key, release the arbor

screw and remove the washer and blade ﬂange

and the blade from the arbor. (Fig. 38)

NOTE: The arbor screw has a LH thread. Turn

clockwise to loosen. Turn counterclockwise to tighten.

• Install the new blade. Make sure the rotation

arrow on the blade matches the clockwise rotation

arrow on the upper guard.

NOTE: The blade teeth should always point downward

at the front of the saw.

• Install the blade ﬂange, washer and arbor screw.

• Lock the arbor and tighten the arbor screw using

moderate force, but do not overtighten.

• Replace the guard operating arm and its retaining

clip. (Fig. 39)

• Ensure the Hex Key is removed and the arbor lock

has released before operating.

• Ensure the blade guard is fully functional before

using the machine.

If required, Blade Bore Reducing Inserts should

only be used in accordance with the manufacturers

instructions.

Fig. 39

Diagram of Spring

Fig. 37

Close up view of arbor lock button