Instruction manual

26
www.evolutionpowertools.com
To reposition:
• Lift up the lever and turn to a convenient position
Release the lever
• Stand to the left side of the handle when making a cut.
When cutting is completed:
• Release the ON/OFF trigger switch, but keep
your hands in position vand allow the blade to
completely stop.
• Allow the Cutting Head has to rise to its upper
position, with the lower blade guard completely
deployed before removing yours hand(s).
• Return the Cutting Head to the perpendicular
position.
• Tighten the bevel lock lever.
COMPOUND CUTTING (Fig. 33)
A compound cut is a combination of a mitre and bevel
cut employed simultaneously.
When a compound cut is required, select the desired
bevel and mitre positions as previously described.
Compound cutting with the sliding carriage system
deployed is possible. Always check that the sliding
blade does not interfere with the machines fence or
any other parts of the machine.
Adjust the upper left hand section of the fence if
necessary.
Fig. 30 Cutting Head set at bevel angle
Fig. 31 View of bevel lock handle
Fig. 32
View of bevel protractor scale & pointer
Fig. 33