Instruction manual

23
www.evolutionpowertools.com
THE MOTOR ON/OFF SWITCH (Fig. 19)
The ON/OFF Motor Trigger Switch is a non-latching
type. It is the upper of the two switches that are
positioned inside the Cutting HANDLE.
• Press the switch to start the motor.
• Release the switch to turn off the motor.
CHOP CUTTING
This type of cut is used mainly for cutting small or
narrow section material. The Cutting Head is gently
pushed down to cut through the workpiece.
The Sliding Carriage should be locked in its
rearmost position. (Fig. 20)
• Slide the Cutting Head to the rear as far as it will go.
• Tighten the slide lock screw. (Fig. 21)
• Place the workpiece on the table and against the
fence and secure with clamp(s) as appropriate.
• Grasp the saw handle.
• Turn the motor on and allow the saw blade to
reach full speed.
• Press the lower guard locking trigger to release
the Cutting Head.
The Lower Guard Locking Trigger (Fig. 22)
• Lower the Cutting Handle downwards and cut
through the workpiece.
• Allow the speed of the blade to do the work, there
is no need to apply undue pressure to the Cutting
Handle.
• When the cut has been completed, release the
ON/OFF trigger switch.
• Allow the blade to come to a complete stop.
• Allow the Cutting Head to rise to its upper
position, with the lower blade guard completely
covering the blade teeth, and the Cutting Head
locked in the upper position, before releasing the
Cutting Handle.
• Remove the workpiece
Fig. 19
Close up view of Cutting Handle switches
Fig. 20
Fig.21
Fig. 22