Instruction manual

23
www.evolutionpowertools.com
NOTE: The arbor screw has a LH thread. Turn
clockwise to loosen. Turn counterclockwise to tighten.
• Install the new ø210 mm blade. Make sure the
rotation arrow on the blade matches the clockwise
rotation arrow on the upper guard.
NOTE: The blade teeth should always point downward
at the front of the saw.
• Install the blade flange, washer and arbor screw.
• Lock the arbor and tighten the arbor screw using
moderate force, but do not overtighten.
• Replace the guard operating arm and its retaining
pivot screw. (Fig. 27)
• Ensure the Hex Key is removed and the arbor lock
has released before operating.
• Ensure the blade guard is fully functional before
using the machine.
USE OF OPTIONAL EVOLUTION ACCESSORIES
(not supplied as original equipment – see Additional
Accessories pp 11)
DUST BAG
A Dust Bag can be fitted to the extraction port at the
rear of the machine. The Dust Bag is for use when
cutting wooden materials only.
• Slide the Dust Bag over the dust extraction port,
ensuring that the spring clip grips the port holding
the Dust Bag securely in place. (Fig. 28)
NOTE: For operational efficiency empty the Dust Bag
when it becomes 2/3 full. Dispose of the contents of
the Dust Bag in an environmentally responsible way. It
may be necessary to wear a dust mask when emptying
the Dust Bag.
NOTE: A workshop vacuum extraction machine can be
attached to the dust extraction port if required. Follow the
manufacturers instructions if such a machine is fitted.
WARNING: Do not use the Dust Bag when cutting
metallic materials.
Fig. 27
Fig. 26
Fig. 28