Instruction manual

www.evolutionpowertools.com

CLEARING JAMMED MATERIAL

• Turn mitre saw “OFF” by releasing the trigger

switch.

• Allow the blade to come to a complete halt.

• Unplug the mitre saw from the mains supply.

• Carefully remove any jammed material from the

machine.

• Check the condition and operation of the safety

guard.

• Check for any other damage to any part of the

machine e.g. the blade.

• Have any damaged parts replaced by a competent

technician and a safety inspection carried out

before using the machine again.

SUPPORTING LONG WORKPIECES

The free end of a long workpiece should be supported

at the same height as the machine table. The operator

should consider using a remote workpiece support if

thought necessary.

INSTALLING OR REMOVING A BLADE

WARNING: Only carry out this operation with the

machine disconnected from the mains supply.

WARNING: Only use genuine Evolution blades which

are designed for this machine.

Ensure that the maximum speed of the blade is higher

than the speed of the motor.

NOTE: It is recommended that the operator considers

wearing protective gloves when handling the blade

during installation or when changing the blade.

• Ensure the Cutting Head is in its upper position.

• Remove the lower guard operating arm from the

machine by removing the pivot screw. (Fig. 23)

Store this screw safely for future use.

• Press the lower blade guard locking lever (A) and

rotate the lower blade guard (B) up and into the

upper blade guard. (Fig. 24)

• Press the black arbor lock button to lock the arbor.

(Fig. 25)

• Using the supplied Hex Key, release the arbor

screw and remove the washer and blade ﬂange

and the blade from the arbor. (Fig. 26)

Fig. 23

Fig. 24

Fig.25