Instruction manual

20
www.evolutionpowertools.com
MITRE CUTTING (Fig. 17)
The rotary table of this machine can be turned through
45
0
to the left or right from the normal cross-cut (0
0
)
position. Positive stops are provided at 45
0
, 40
0
, 35
0
,
30
0
, 22.5
0
, 15
0
, 10
0
and 5
0
to both the right hand and
left hand sides.
• Loosen the Mitre Locking Screw, (Fig. 18) by
turning it anti-clockwise.
• Turn the rotary table to the desired angle. A mitre
angle protractor scale is incorporated into the
rotary table to aid setting.
• Tighten the Mitre Locking Screw when the
desired angle is achieved.
NOTE: It is important to tighten the Mitre Locking
Screw even if a Positive Stop has been selected.
NOTE: The Mitre Locking Screw has a sprung loaded
repositionable handle. Repositioning may be necessary
to ensure that the locking screw can be tightened
sufficiently to secure the table.
To reposition:
• Lift up the lever and turn to a convenient position.
• Release the lever.
BEVEL CUTTING TILTING THE CUTTING HEAD
A bevel cut (Fig. 19) is made with the rotary table set
at 0
0
mitre.
NOTE: It may be necessary to adjust the upper section
of the Fence to provide clearance for the moving
Cutting Head.
The Cutting Head can be tilted from the normal 0
0
(perpendicular position) to a maximum angle of 45
0
from the perpendicular to the left hand side only.
Fig. 17
Fig 18
Fig. 19