Instruction manual

17
www.evolutionpowertools.com
45
0
Bevel Stop Adjustment
• Loosen the Bevel Lock Handle and tilt the Cutting
Head completely to the left until it rests against
the 45
0
stop.
• Use a Set Square to see if the blade is at 45
0
to
the table (avoiding the TCT tips).
• If the saw blade is not in exact alignment
adjustment is necessary.
• Return the Cutting Head to its upright position.
• Loosen the locknut on the 45
0
Bevel Adjustment
Screw.
• Use a Hex Key to adjust the Adjustment Screw in
or out as required. (Fig. 11)
• Tilt the Cutting Head to the 45
0
setting and
recheck for alignment with the Set Square.
• Repeat the above steps until the correct angular
alignment is achieved.
• Tighten the Adjustment Screw locknut securely
once alignment is achieved.
Fig. 10
Fig. 11
Fig. 9