Instruction manual

16
www.evolutionpowertools.com
BEVEL ANGLES (0
0
AND 45
0
)
0
0
Bevel Stop Adjustment
• Ensure that the Cutting Head is in the locked
down position with the latching pin fully engaged
in its socket. (see Fig.6)
• Ensure that the Cutting Head is upright, against its
stop and the bevel pointer is indicating 0
0
on the
scale. (Fig. 7)
• Place the Set Square on the table with one short
edge against the table and the other short edge
against the blade (avoiding the TCT tips). (Fig. 8)
• If the blade is blade is not 90
0
square with the
mitre table adjustment is required.
• Loosen the Bevel Lock Handle and tilt the Cutting
Head to the left.
• Loosen the locknut on the Bevel Angle
Adjustment Screw. (Fig. 9)
• Use a Hex Key to turn the screw in or out to adjust
the blade angle.
• Return the Cutting Head to its upright position
and recheck the angular alignment against the Set
Square.
• Repeat the above steps until correct angular
alignment is achieved.
• Tighten the Bevel Angle Adjustment locknut
securely.
•
0
0
Bevel Pointer Adjustment
NOTE: The operator must be satisfied that the blade
is set exactly perpendicular to the table when in the
upright position and against its stop.
• If the pointer is not in exact alignment with the
0
0
mark on the protractor scale adjustment is
necessary.
• Loosen the Bevel Pointer screw using a #2 Phillips
screwdriver. (Fig. 10)
• Adjust the Bevel Pointer so that it is in alignment
exactly with the 0
0
mark.
• Retighten the screw.
Fig. 6
Fig. 7
Fig. 8