Instruction manual

13
www.evolutionpowertools.com
ASSEMBLY and PREPARATION
WARNING: Always disconnect the saw from the
power source before making any adjustments.
PERMANENTLY MOUNTING THE
MITRE SAW
To reduce the risk of injury from unexpected saw
movement, place the saw in the desired location either
on a workbench or other suitable machine stand. The
base of the saw has four mounting holes through
which suitable bolts (not supplied) can be placed to
secure the miter saw. If the saw is to be used in one
location, permanently fasten it to the workbench using
appropriate fastenings (not supplied). Use locking
washers and nuts on the underside of the workbench.
(Fig. 1)
• To avoid injury from flying debris, position the saw
so that other people or bystanders cannot stand
too close (or behind) it.
• Locate the saw on a firm, level surface where
there is plenty of room for handling and properly
supporting the workpiece.
• Support the saw so the machine table is level and
the saw does not rock.
• Bolt or clamp the saw securely to its support
stand or workbench.
Fig. 1 1) Hex headed bolt
2) Spring washer
3) Flat washer
4) Mitre saw base
5) Workbench
6) Flat washer
7) Spring washer
8) Hex nut
9) Lock nut
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)