Instruction manual

www.evolutionbuild.com

6. Install the new 210 mm (8-1/4”) blade. Make sure the

rotation arrow on the blade matches the clockwise rotation

arrow on the upper guard. The blade teeth should always

point downward at the front of the saw.

7. Install the blade washer and arbor screw.

8. Lock the arbor and use the allen key to secure the blade.

9. Tighten the arbor screw using moderate force, but do not

overtighten.

10. Replace the guard operating arm using the stored screw.

(Fig. 1)

11. Ensure that the allen key is removed and the arbor lock

has released before operating the machine

WARNING: Ensure the blade guard is fully functional before

using the machine.

Note: Spacers and spindle rings should not be used with this

machine and/or blade.

3. Debris collection bag

The Debris Collection Bag should be attached at the debris

extraction port.

1. Slide the frame of the collection bag on to the outlet of the

extraction port, ensuring that it is ﬁrmly connected.

2. To release the bag, slide the frame in the opposite direction.

Note: To ensure optimal dust collection, empty the dust bag

when it becomes approximately 2/3 full.

WARNING: Before cutting metal materials, the collection

bag should be removed and replaced with a blanking plug.

Reinstate the dust bag when cutting wood.

OPERATING INSTRUCTIONS

Disconnect the Mitre Saw and inspect your Saw before

each use.

Note: It is important that the operator is adequately trained

in the use, adjustment and operation of the machine and has

read this instruction and safety manual before commencing

operations.

WARNING: To reduce the risk of injury, always unplug the

saw before changing or adjusting any of the machines parts.

Compare the direction of rotation arrow on the guard to

direction arrow on the blade. The blade teeth should always

point downward at the front of the saw. Check the tightness

of the arbor screw.

Fig 3

Fig 4

OPERATION