Instruction manual

Fig 35
Close up view of push stick
in its storage position.
Fig 36
View of blade storage.
Fig 37
23
www.evolutionfury.com
Note
Use only a genuine Evolution Riving Knife, as this is a dedicated
component for this machine. Non genuine parts could be
dangerous. If in any doubt, please contact the Helpline.
Push Stick
A plastic push stick is provided with the machine and has
its own dedicated storage brackets to the RH side of the
machines main body. See Fig 35. When not in use store the
push stick on the machine.
Note
If the push stick becomes damaged it should be replaced. If
the operator makes their own push stick, we recommend that
it follows the same pattern as that supplied. Replacement
push sticks are available from Evolution Power Tools.
Blade Storage
A blade storage facility is available at the rear of the machine.
See Fig 36. Undo the centre hand nut and place any spare
blades onto the ø25.4mm metal flange. Secure the blades
with the centre hand nut.
ENVIRONMENTAL PROTECTION
Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. Check
with your Local Authority or retailer for recycling advice.
UK PLUG REPLACEMENT
See FIG. 37. The fuse in the main plug of your power tool should
always be replaced with one of identical rating. Check the
voltage given on your power tool matches the supply voltage.
The power tool is supplied with a fitted plug, however if you
should need to fit a new plug follows the instruction below.
IMPORTANT
The wire in the mains lead are coloured in accordance with
the following code: Blue ---Neutral Brown ---Live The wire that
is coloured blue must be connected to the terminal that is
marked with the letter N. The wire that is coloured brown must
be connected to the terminal that is marked with the letter L.
A 13AMP (BS1363 or BS1363/A) plug must be used and a 13
AMP fuse must be fitted. A 13AMP (BS1363 or BS1363/A)
plug must be used and a 13 AMP fuse must be fitted.
13AMP