Instruction manual

13
www.evolutionfury.com
2. Captive nuts are incorporated into the RH and LH edges of
the table. Attach the table extensions (single hole to the front)
to the table top using the ø5mm socket headed screws and
washers.
3. Ensure that the saw table edge and extension table edge
are flush and level with each other. Tighten the ø5mm socket
screws. See Fig 7.
4. Using a straight edge or similar placed across the table and
extension to ensure alignment, position each bracing strut to
its body mounting turret. Use the hex headed self tapping
screw to secure each bracing strut to its turret. The screw will
cut its own thread into the turret slot. See Fig 8.
5. Final micro adjustment and alignment of the table extensions
is possible by repositioning the relevant fixing screw in their slots.
4. Assembling the Rip fence
The rip fence guide has an adjustable aluminium faceplate. For
normal use this should be attached to the steel carrier of the
rip fence with the deep (60mm) side in the vertical position
and on the LH side of the carrier. See Fig 9.
1. Place the two ø6mm x 60mm dome headed coach-bolts
into the two through holes in the carrier, dome heads to the
LH side.
2. Put washers and the finger nuts (by only a couple of threads)
onto the RH side of the carrier.
3. Slide the aluminium faceplate onto the bolt heads.
4. Tighten the two finger nuts.
Note
The magnifier in the Rip Fence clamp should be visible.
Fig 7
Close up view of top of
machine showing table to
extension table join.
Fig 8
Close up detail. Fixing
strut to turret.
Fig 9
Close up view of the
assembled Rip Fence.