Instruction manual

CUT AND REMOVE

UNWANTED HOSETAILS

CONNECTION TO YOUR PIPEWORK

Connection with flexible hose (evo30 and evo55 only)

The evo30 and evo55 is supplied with two universal hosetails to take 1”, 1¼”,

and 1½” diameter flexible hose. If you are using one of the two larger sizes, the

smaller sections of the hosetails must be cut off to ensure sufficient water flow and

to prevent possible damage to the pump. We recommend that you use the largest

diameter hose available. The hosetails should be trimmed away from the unit as

shown in the diagram below. Once the hosetails have been trimmed, attach them to

the unit as shown below. Secure the flexi-hose to the hosetail with a stainless steel

hose clip (not provided).

The two universal hosetails supplied with the evo30 and evo55, should be screwed

into the inlet / outlet at either end of the unit. Hosetails should be tightened using

hand pressure only. Ensure that the O-rings are in position before assembling.

Please note that there is no correct direction of flow through the unit, either end of

the unit may be used as the inlet or outlet.

* Pipework fittings are not provided with the evo110.

CUT

1½” 1¼” 1”

CUT

Screw into

evo30

or evo55

(Hand tight

only)

Use these fittings to connect 1½" Flexible Hose to an evo30 and evo55.

Use a stainless steel hose clip (not supplied) to secure the hose to the fitting.

CONNECTION TO FLEXIBLE HOSE

EA FITTING CODE:

HOSETAIL15TH

Threaded Hosetail Fitting

O-ring

This fitting is provided with the

evo30 and evo55 only.