230mm (9”) TCT Steel Cutting Circular Saw Instruction Manual Read instructions before operating this tool. www.evolutionsteel.
Evolution Power Tools definition of RoHS Compliance: EC - DECLARATION OF CONFORMITY • The product does not contain any restricted substances in We, Evolution Power Tools Limited, Venture One, concentrations and applications banned by the directive and Longacre Close, Sheffield, S20 3FR as the supplier of the for components, the product is capable of being worked at product listed below: the higher temperatures required by lead-free soldering.
IMPORTANT GENERAL SAFETY RULES Please read these operating and safety instructions carefully SAVE THESE INSTRUCTION FOR FUTURE REFERENCE. and completely. For your own safety, before using this equipment check that the voltage is correct and that all WARNING! handles and parts are firmly secured. If you are uncertain Read and understand all instructions before operating about any aspect of using this equipment, please contact our this product.
3) Personal Safety 4) Power Tool Use & Care a) Stay alert, watch what you are doing and use common a) Do not force the power tool. Use the correct power tool sense when operating a power tool. Do not use a power tool for your application. The correct power tool will do the job while you are tired or under the influence of drugs, alcohol or better and safer at the rate for which it was designed. medication.
SPECIFIC SAFETY RULES & SYMBOLS ADDITIONAL SPECIFIC SAFETY RULES WARNING! a) DANGER: Keep hands away from cutting area and the Do not operate machine if warning and / or instruction labels blade. Keep your second hand on auxiliary handle, or motor are missing or damaged. Contact evolution power tools for housing. If both hands are holding the saw, they cannot be replacement labels. cut by the blade. b) Do not reach underneath the workpiece.
FURTHER SAFETY INSTRUCTIONS FOR ALL SAWS Causes & Operator Prevention Of Kickback: SAFETY INSTRUCTIONS FOR SAWS a) Check lower guard for proper closing before each use. Do not operate the saw if lower guard does not move freely and - kickback is a sudden reaction to a pinched, bound or close instantly. Never clamp or tie the lower guard into the misaligned saw blade, causing an uncontrolled saw to lift up open position.
SPECIFICATIONS OPERATION Model EVO230-HDX Specifications What You Should Know Before Sawing: Motor (230v or 115v 50/60 Hz) (Watts) 1750 Maximum Box (1/4” 6mm Wall 900) 84mm Warning! Maximum Box (1/4” 6mm Wall 450) 53mm Never start the saw with cutting edge of saw blade contacting Optimum Cutting Thickness (Mild Steel Plate) 12mm work surface. Do not retract blade guard manually. Guard RPM No Load (min-1) 2700 Recommended Maximum Duty Cycle retracts automatically.
Operating Advice Do not operate the tool in damp or wet conditions, as electric Always clamp the work piece on a rigid support such as a shocks may result. Always use both hands to operate the bench or saw horses where possible. This tool is equipped tool. Always ensure that the material you are working on is with a safety start feature – to start the tool, you must securely clamped.
MAINTENANCE ENVIRONMENTAL PROTECTION Maintenance & Troubleshooting Recycle unwanted materials instead of disposing of them Keep tool, cord, and carry case clean and free from chips. as waste. All tools, hoses and packaging should be sorted, Avoid using cleaning products, which include benzene, taken to the local recycling center and disposed of in an trichloroethelene, chloride, or ammonia as these can damage environmentally safe way. plastic parts.
EVO230-HDX CUTTING THROUGH 1/2” MILD STEEL PLATE 10 www.evolutionsteel.
EVO230-HDX TRIGGER SWITCH EVO230-HDX FIGURE 1 EVO230-HDX TILTING BLADE EVO230-HDX FIGURE 2 EVO230-HDX 1750W MOTOR EVO230-HDX FIGURE 3 www.evolutionsteel.
