Specifications

4
CHECKS AND MAINTENANCE
45
GB
2 mm
NOTE:
During this procedure, continuously top up
the brake pump thank to replace the oil that
is out fl owing.
•Remove the tube.
•Replace the rubber cap.
Close the oil reservoir cap.
REAR BRAKE LINING CONTROL
In order to verify the wear condition of rear
brake is enough to view the caliper from the
back side, where is possible to glimpse the
brake lining tails which will have to show
a brake of 2 mm in thickness. If the stratum
is lesser let’s start replacing them.
NOTE:
Perform the check according to the times
shown in the table on page 59.
To replace, contact authorised Betamotor
customer service.
CLUTCH CONTROL
CHECK OIL LEVEL
To check the oil level in the clutch pump,
fi rst remove cover 1.
Remove the two screws 2 and take off
cover 1 together with the rubber bellows.
With the clutch pump in a horizontal posi-
tion, the level of the oil should be 5 mm
below the upper rim.
2
1