Instruction manual

Connection using rigid pipe (evo30, evo55 and evo110)

The unit may also be rigid plumbed by the use of an adaptor (not supplied).

See table on page 6 for relevant fittings. These fittings will screw directly into the

evoUV and will enable you to connect to the relevant size pipework.

The table below shows the inlet and outlet sizes of the evoUV:

MODEL UK AND EUROPE USA AND CANADA

evo30 1½” BSP N/A

evo55 1½” BSP 2” NPT

evo110 2” BSP 2” NPT

CUT AND REMOVE

UNWANTED HOSETAILS

CUT

1½” 1¼” 1”

CUT

CONNECTION TO YOUR PIPEWORK

Connection with flexible hose (evo30 and evo55 only)

The evo30 and evo55 is supplied with two universal hosetails to take 1”, 1¼”,

and 1½” diameter flexible hose. If you are using one of the two larger sizes, the

smaller sections of the hosetails must be cut off to ensure sufficient water flow and

to prevent possible damage to the pump. We recommend that you use the largest

diameter hose available. The hosetails should be trimmed away from the unit as

shown in the diagram below. Once the hosetails have been trimmed, attach them

to the unit as described on page 7. Secure the flexi-hose to the hosetail with a

stainless steel hose clip (not provided).