User Manual

www.evolutionpowertools.com

OPERATING INSTRUCTIONS

INSTALLING/REMOVING A DISC

WARNING: Always disconnect the machine from the power

supply before attempting to install or remove a Cutting Disc.

• Ensure that the machines arbor and the blade flanges are

clean and free from dust and debris.

• Ensure that the direction of rotation marked on the blade

matches the direction of rotation marked on the machines

guard.

Note: This machine is supplied with two (2) blade flanges. These

can accommodate blades with either a ø20mm (ø3/4”) or ø22.2

(ø7/8”) arbor hole depending upon how they are installed.

• Install blade flange ‘A’ on the inner side when the arbor hole

in the cutting disc is ø22.2mm (ø7/8”). FIG. 1

• Install the blade flange ‘B’ on the inner side when the arbor

hole in the cutting disc is ø20mm (ø3/4”) FIG. 2

• Install the cutting blade and outer blade flange, washer and

arbor bolt.

• Press the arbor lock to lock the machines arbor.

• Tighten the arbor bolt using the supplied spanner. FIG. 3

• Release the arbor lock and check by hand that the Cutting

Disc is secure and correctly positioned on the arbor and that

if rotates freely.

Note: The arbor bolt has a Left Hand thread. Turn

counterclockwise to tighten the arbor bolt. Turn clockwise to

loosen the arbor bolt.

To remove a Cutting Disc, reverse the above Installation

procedure.

FIG. 1

FIG. 3

FIG. 2