Specifications
7
10.8V Li-Ion
Jigsaw
SPECIFICATION
PURE BATTERY JIGSAW
The declared vibration total value has been
measured in accordance with a standard
test method and may be used for comparing
one tool with another.
The declared vibration total value may also
be used in a preliminary assessment of
exposure.
WARNING: The vibration emission during
actual use of the power tool can differ from
the declared total value depending on the
ways in which the tool is used. The need
to identify safety measures and to protect
the operator are based on an estimation
of exposure in the actual conditions of use
(taking account of all parts of the operating
cycle, such as the times the tool is switched
off, when it is running idle, in addition to
trigger time)
OPERATING INSTRUCTIONS
Note: Before using this tool, read the
instruction manual carefully.
BEFORE USE
A Battery Pack must be inserted into the
tool as detailed below. It is important that
the Battery Pack is of the designated type
recommended for this machine.
Newly purchased Battery Packs do not
come fully charged. Please refer to the
PURE CHARGER MANUAL for full details
on how to charge the Battery Pack for this
machine
1. INSTALLING OR REMOVING THE
BATTERY PACK
Check that the battery pack is of the
designated type for this machine. We
recommend that the trigger switch is locked
in the OFF position when removing or
inserting the Battery Pack. Refer to section
3 below.
a. Slide the Battery Pack into the base of
the tools handle. The Battery can only fit
one way round.
b. Gently push the Battery Pack fully into the
tools handle to engage the locking tabs. The
electrical connections inside the handle will
be made automatically.
c. To remove the Battery Pack, simply press
the two locking tabs with your finger and
thumb and withdraw the Battery Pack from
the handle.
2. INSTALLING OR REMOVING A BLADE
Note: The battery pack must be disconnected
from the machine when installing or
removing the blade.
1. Remove the battery pack.
2. Check that the jigsaw blade is of the
correct type.
3. Pull back on the chuck sleeve using your
finger and thumb of one hand.
4. Insert the blade into the chuck fully
ensuring that the blade teeth face forwards.
5. Release the chuck sleeve.
6. Check to ensure the blade is securely
gripped by the chuck.
7. Check to ensure that the back of the
blade has engaged into the groove in the
guide roller.
8. Replace the battery pack.
Voltage: 10.8V-DC
No Load Speed: 0-2000 -
-strokes per minute
Stroke Length: 18 mm
Blade Type: T-shank
Chuck Capacity: 10 mm
Noise and Vibration Data
Sound Pressure:
L
PA
84.3dB(A) K=3dB
Sound Power: L
wA
95.3dB(A) K=3dB
Vibration: 6.613 m/s
2
K=1.5 m/s
2