Instruction manual
®
11
www.evolutionpowertools.com
5. LASER CUTTING GUIDE
This jigsaw is tted with a Laser Guide which can be useful when
cutting straight lines. Only switch the Laser Guide on when you are
about to make a straight cut, and switch it off when the cut has been
completed. The switch is located on the front of the machine. Press
the ‘I’ side of the rocker switch to turn the Laser Guide ‘On’. Press
the ‘O’ side of the rocker switch to turn the Laser Guide ‘Off’.
WARNING: Do not stare directly at the laser beam. A hazard may
exist if you deliberately stare into the beam. Please observe all of
the following safety rules.
• The laser beam must not be deliberately aimed at personnel and
must be prevented from being directed towards the eyes of a
person or animal.
• Always ensure that the laser beam is used only on workpieces that
have non-reective surfaces, i.e natural wood or matt surfaces etc.
• Never exchange the laser module assembly for a different type or
class of laser.
• Repairs to the laser module must only be conducted by Evolution
Power Tools or their authorized agent.
REPLACEMENT OF LASER BATTERIES
Power for the Laser Guide is provided by two (2) ‘AAA’ Cells. When
exhausted these should be replaced.
Access to the battery compartment is gained by loosening the screw
and removing the battery compartment cover. (Fig. 5)
Observe the polarity of the cells and replace the cover after cell
replacement.
Fig 5
Close up view of battery
compartment cover
and