Specifications

21
www.evolutionpowertools.com
EN
ES
FR
BRUSH CHECKING AND/OR REPLACEMENT
• Disconnectthemachinefromthepower
supply.
• Placethemachineonalevel,securesurface.
• Unscrewandremovethetwo(2)brush
retaining caps from the motor housing.
• Withdrawthebrushes.
Note: If the carbon brush is less than ¼” long,
or if there are signs of burning or damage to
the carbon or the spring, replace the brushes.
• Fitthenewbrushes.
• Refitthebrushretainingcaps
• Runthemachinewithoutloadforseveral
minutes after brush replacement. This will
aid the ‘bedding in’ process.
Note: If, upon checking, the brushes are found
to be still serviceable, they can be returned to
their original position. It is important that they
are replaced in the same position as they were
removed from the machine.
ENVIRONMENTAL PROTECTION
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authority or retailer for recycling advice.