Specifications

17
www.evolutionpowertools.com
EN
ES
FR
Auxiliary Handle (Fig. 7)
The auxiliary handle (supplied) can be screwed into the boss
found on the Bevel Locking Quadrant.
This handle will provide the operator with a convenient position
for their left (or right) hand during cutting operations.
Adjustment of the Cutting Depth
Release the lever lock (Fig. 8) to adjust to the required cutting
depth. In most cases the depth should be set at maximum
unless there are obstructions below the work surface.
Note: Always check to see if there are any obstructions below the
work surface that could influence the setting of the cutting depth.
Tighten the lever lock securely to lock in the required position.
Adjustment of the Cutting Angle
• Loosenthebevellockingscrewfoundatthefrontofthesaw.
• Loosentherearbevellockingscrewfoundattherearofthe
machine’s base plate.
• Tiltthebladetotherequiredangle(Fig. 9)
• Tightenbothbevellockingscrewssecurely.
Note: An angle scale (0 – 45
0
) is incorporated into the bevel
locking quadrant to aid setting.
OPERATING ADVICE
Carry out routine safety checks each time you use the machine.
Check that all safety guards are operating correctly, and that all
adjustment handles/screws are tightened securely.
Check that the blade is secure and installed correctly. Also check
that it is the correct blade for the material being cut.
Check the integrity of the power cord.
Always clamp the workpiece to a rigid support such as a bench
or saw horse whenever possible.
Fig. 7
Fig. 8
Fig. 9