User manual

Evolution Safari Scooters
8
Seat Height Adjustment (Fig 5)
Remove seat as described (fig 4). Remove
battery pack (refer to disassembly section).
Using two 13mm wrenches, remove locking
bolt and nut. Adjust seat post up or down to
desired position. The seat height can be adjusted
to five different positions by inserting the
locking bolt in the desired hole. Replace washer
and nut and tighten. Replace ba ttery pack and seat.
Serial Number (Fig 5)
Serial number is located on the seat post. It is
on a white sticker with a barcode. The serial
number is 13 alphanumerical digits beginning
with the number 1.
Armrest Width Adjustments (Fig 6)
On the unders ide back of the seat there are two
armrest hand knobs, one on each side. Turn hand
knobs counterclockwise to loosen.
Loosening the armrest hand knob allows the armrest
width to be adjusted or arm rest to be removed.
Once the desired positions of the armrests are set,
tighten the hand knobs by turning clockwise to
lock the armrests into place.
Armrest Adjustments (Fig 6)
The armrests may be pulled up and out of the
way for sideways transfer. Pull armrest up and
back.
The arm rest angle may be adjusted by turning
the adjustment screw either clockwise or
counterclockwise depending on the desired angle.
Figure 5
Figure 6
Arm
rest
tightening
knob