Use and Care Manual

24
www.evolutionpowertools.com
0
0
Bevel Pointer Adjustment
NOTE: The operator must be satised that the blade is set
exactly perpendicular to the table when in the upright position
and against its stop.
• If the pointer is not in exact alignment with the 0
0
mark on the
protractor scale adjustment is necessary.
• Loosen the Bevel Pointer screw using a #2 Phillips
screwdriver. (Fig. 15)
• Adjust the Bevel Pointer so that it is in alignment exactly
with the 0
0
mark.
• Retighten the screw.
45
0
Left Hand Bevel Stop Adjustment
• Loosen the Bevel Lock Handle and tilt the Cutting Head
completely to the left until it rests against the 45
0
stop.
• Use a Set Square to see if the blade is at 45
0
to the table
(avoiding the TCT tips).
• If the saw blade is not in exact alignment adjustment is necessary.
• Return the Cutting Head to its upright position.
• Loosen the locknut on the 45
0
Bevel Adjustment Screw.
• Use a Hex Key to adjust the Adjustment Screw in or out as
required. (Fig. 16)
• Tilt the Cutting Head to the 45
0
setting and recheck for
alignment with the Set Square.
• Repeat the above steps until the correct angular alignment
is achieved.
• Tighten the Adjustment Screw locknut securely once
alignment is achieved.
45
0
Right Hand Bevel Stop Adjustment
• Loosen the Bevel Lock Handle.
• Pull out the Right Hand Bevel Access Locking Pin and twist
it ¼ of a turn to hold it in the disengaged position. This will
enable access to the right hand bevel angles. (Fig. 17)
• Tilt the Cutting Head completely to the right until it rests
against the 45
0
stop.
• Use a Set Square to see if the blade is at 45
0
to the table
(avoiding the TCT tips).
• If the saw blade is not in exact alignment adjustment
is necessary.
• Return the Cutting Head to its upright position.
• Loosen the locknut on the 45
0
Bevel Adjustment Screw.
• Use a Hex Key to adjust the Adjustment Screw in Or out as
required. (Fig. 18)
Fig. 16
Fig. 17
Fig. 18
Fig. 15