Use and Care Manual
WHEN FITTED WITH A CORRECT
BLADE THIS MACHINE CAN BE
USED TO CUT:
• Wood, Wood derived products
(MDF, Chipboard, Plywood, Blockboard,
Hardboard etc),
• Wood with nails,
• 50mm mild steel box section with 4mm
wall at HB 200-220,
• 6mm mild steel plate at HB 200-220.
Note: Wood containing non galvanised nails
or screws, with care, can be safely cut.
Note: Not recommended for cutting
galvanised materials or wood with embedded
galvanised nails. For cutting stainless steel
we recommend Evolution dedicated stainless
steel blades.
PROHIBITED USE OF THIS
POWER TOOL
WARNING: This product is a Multipurpose
Sliding Mitre Saw and must only be used as
such. It must not be modied in any way,
or used to power any other equipment or
drive any other accessories other than those
mentioned in this Instruction Manual.
WARNING: This product is not intended for use
by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been
given supervision or instruction concerning the
safe use of the product by a person responsible for
their safety and who is competent in its safe use.
ELECTRICAL SAFETY
CONNECTION OF THE DOUBLE INSULATED
MAINS PLUG- UK ONLY
IMPORTANT: The wires in the mains
lead tted to this product are coloured in
accordance with the following code:
Brown: Live (L) or Red
Blue: Neutral (N) or Black
THIS PRODUCT IS DOUBLE INSULATED
AND THEREFORE DOES NOT REQUIRE A
CONNECTION TO EARTH.
• THE 3 PIN PLUG MUST COMPLY TO
BS1363/A.
• THE FUSE MUST COMPLY TO BS1362.
If for any reason the 13 amp moulded plug
tted to this product requires replacing, the
replacement must be wired in accordance with
the following instructions:
• Connect the Blue wire to the terminal
marked Neutral (N).
• Connect the Brown wire to the terminal
marked Live (L).
Ensure that the outer insulation is gripped
by the cord grip and that the wires are not
trapped when replacing the plug cover.
A 13 amp (BS1362) fuse must be tted in the plug.
Do not connect any wire to the earth pin
MARKED E on the 3 pin plug.
If in any doubt consult a qualied electrician.
There are no user serviceable parts inside
this product except those referred to in the
manual. Always refer servicing to qualied
service personnel. Never remove any part of
the casing unless qualied to do so; this unit
contains dangerous voltages.
8
www.evolutionpowertools.com