Use and Care Manual

8
www.evolutionpowertools.com
DEPLOYING THE LEGS PRIOR TO ASSEMBLY
Note: It is much easier to set up or knock down the stand without
a saw being attached.
• Pushthelocking/unlockingbutton(Fig. 1) and deploy all
4legs,ensuringtheyarelockedintheirserviceposition.
ASSEMBLY INSTRUCTIONS
• Screwthelonglockingscrews(F) into the guides. (Fig. 2)
• Slidetheworksupportbrackets(D) onto the extension arms
and lock in place with a long locking screw (F). (Fig. 3)
• Inserttheworksupportroller(C) into the bracket and lock
in place using a long locking screw. (F) (Fig. 4)
For Normal Cutting Operations:
• Thetopoftheroller(s)shouldbelevelwiththesurfaceof
the Mitre Saws rotary table.
• Theextensionarm(s)shouldbepositionedbegivemaximum
support to the workpiece.
For Repetitive Cutting Operations:
• The‘stopface’(Fig. 4a) can be positioned at the required
distance from the saw blade.
• Therequiredworksupportshouldbeadjustedsothatthe
‘stopshelf’(Fig. 4b)
is level with the Mitre Saws rotary table and facing towards
the saw.
• Adjusttherelevantextensionarmuntilthe‘stopface’isat
the required distance.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
(a)
(b)