Use and Care Manual

11
www.evolutionpowertools.com
EN
DE
FR
MOUNTING UNUSUAL or UNCOMMON MITRE SAWS
Ifyourmitresawis‘uncommon’or‘unusual’anadaptorplate
may be necessary.
The adaptor plate can be bolted to the two (2) saw mounting
brackets, and when attached to the stand should provide a
suitable mounting platform for most mitre saws.
The mitre saw can then be screwed or bolted to the adaptor plate.
We recommend at least 25 mm thick plywood or a piece of
32mmor40mmkitchenworktopforthisadaptorplate.
Consult the manufacturer of the saw for any special
adjustments, other requirements or xings etc needed to
permanently mount your saw to a worktop.
• Asquareorrectangularpieceofplywood,orworktop
shouldbesourcedwhichwilltthe‘footprint’and
mounting hole conguration of your saw.
• Theadaptorplateshouldbedrilledandboltedtothesaw
mounting brackets using appropriate bolts, or xings etc.
• Theadaptorplatecanthenbeattachedtothemitresaw
stand and the mitre saw positioned upon the adaptor plate.
• Forstabilityduringuse,careshouldbetakentoensurethat
the mitre saw is positioned on the adaptor plate so that
most of the bulk and weight of the saw is centrally located
over the two (2) mitre saw stand crossbars.
• Usesuitablexingstoattachthemitresawtotheadaptorplate.
• Checkthestabilityofthemachineandinstallationoverthe
full range of operating conditions.
Note: Usually the machines fence should align as closely as
possible with the centre-line of the mitre saw stand rear crossbar.