Use and Care Manual

10
www.evolutionpowertools.com
MOUNTING EVOLUTION MITRE SAW TO THE MITRE STAND
Note: The Evolution Mitre Saw Stand is suitable for most
Evolution Mitre Saws.
• Removeandsafelystorethefour(4)plasticfeetfrom
underneath the base of the mitre saw. (Fig. 7)
• Removeandsafelystorethestabilityblockfrom
underneath the positive stop locking lever. (Fig. 8)
• Attachthemachinetothesawmountingbrackets(A) using
suitable bolts, washers and locknuts etc. The locking handles
must be positioned to the front of the mitre saw. (Fig. 9)
• Ensurethatthexingsuseddonotprotrudesofarthroughthe
base of the machine that they interfere with any other parts of
theMitreSaw.Onlytighten‘ngertight’atthisstage.
• Hookthefrontofthebracketsoverthefrontofthemitre
saw stands main frame tubular crossbar. (Fig. 10)
• Pushthebackofthebracketsdowntoengagethemonto
the mitre saw stands crossbars. (Fig. 11)
• Lockthebracketsintoplacebygentlydepressingthe
locking levers. (Fig. 12)
• Ifnecessaryre-postionthemitresawonthebracketsso
that the machines fence aligns as near centrally with the
rear tubular crossbar of the mitre stand as possible. This will
ensure the greatest stability of the machine and mitre saw
stand during cutting operations.
• Whenthemitresawiscorrectlypositionedonthestand,
securelytightenthefour(4)mountingbolts.
Fig. 7
Fig. 8
Fig. 9
Fig. 10 Fig. 11 Fig. 12