Owner's Manual
12
COLOR
COLOR button: Makes the color flame effect
changing.
NOTE: color effect s tays on until power button
is turned off. Color flame effect must be on for
fireplace to turn on.
1. Press once. Flame color effect gets
changing.
2. Press again until desired setting is
reached.total 3 colors.
HEATER
HEATER button: Turns heater on and off.
NOTE: The heater only works when the f lame effect is on. If the flame effect is off, the heater
will not turn on.
NOTE: To prevent overheating, the heater blows cool air for 10 seconds
Temperatu
re
1. Press once: Touch panel indicator becomes active.
2. Press again until desired setting is reached. Digital display shows setting circles as
belows.
NOTE: Press the button for 5 seconds to switch between °C and °F
LED Ember light button ( 1 ): Makes the
color on bottom effect changing.
NOTE: Ember color effect stays on until
power button is turned off.
1. Press once. Ember color effect gets
changing.
2. Press again. until desired setting is
reached, in total 10 colors recycling.
LED Bottom light button ( 2 ): Makes the
color on bottom effect changing /flash
changing automatically.
NOTE: Ember color effect stays on until
power button is turned off.
1. Press once. Ember color effect gets
changing automatically.
2. Press again. Ember color effect gets
with flash changing automatically .
NOTICE
When the fireplace is first turned on, a slight odor may be present. This is normal and
should not occur again unless the fireplace is not used for a long period of time.
NOTICE
To improve operation, aim the remote control at the front of the fireplace. DO NOT press
the buttons too quickly. Give the unit time to respond to each command.
Remote Control Battery Information
This remote control uses two CR2025 battery (included).
Instructions for battery installation are on the Remote Control battery compartment.
NEVER dispose of batteries in fire. Failure to observe this precaution may result in an
explosion. Dispose of batteries at your local hazardous material processing center.