Owner's Manual

11
Power
Plug the power cord into a 110~120 Volt 15 Amp grounded outlet (see IMPORTANT SAFETY INFORMATION
on Pages 2 and 3). Make sure the outlet is in good condition and that the plug is not loose. NEVER exceed the
maximum amperage for the circuit. DO NOT plug other appliances into the same circuit.
Methods of Operation
This electric fireplace can be operated by the TOUCH PANEL, located on the right side panel of the fireplace
(see figure below), or by the battery-powered REMOTE CONTROL.
The operation and functions of the two methods are the same.
Before operating, please review the IMPORTANT SAFETY INFORMATION on Pages 2 and 3, and heed all
warnings.
Remote Control &Control Panel Operation
BUTTON FUNCTION ACTION & INDICATION
POWER
ON: Enables control panel functions and
remote control. Turns on flame effect.
OFF: Disables control panel functions and
remote control. Turns off flame effect.
1. Press once. Indicator light turns on. Power
turns on. All functions enabled.
2. Press again.Flameeffectturnsoff.Unit
goes to standby. All functions turn off.
TIMER
TIMER button: Controls timer settings to turn
off fireplace at selected time.
Settings range from 0.5 hours to 7.5 hours.
1. Press once. Indicator light turns on. Timer is
set to 0.5 hours.
2. Press again until desired setting is
reached. Indicator lights show setting.
FLAME
FLAME button: Makes flame effect dimmer
and brighter.
NOTE: Flame effect stays on until power
button is turned off. Flame effect must be on
for fireplace to turn on.
1. Press once. Flame brightness effect gets
changing.
2. Press again. until desired setting is reached.