Owner's Manual

10
the appliance directly to the house hold wiring.
This appliance must be electrically connected and grounded in accordance with local codes, if hard wired. In
the absence of local codes, use the current CSA C22.1 CANADIAN ELECTRICAL CODE in Canada or the
current ANSI/NFPA 70 NATIONAL ELECTRICAL CODE in the United States.
A. Remove the cover p late from the right side B. Remove the wire connectors from the power
bottom of the appliance by removing the three cord. The power c ord may be discarded.
screws, as shown above.
C. Take the new cover plate, su pplied in the hardware bag. Punch out the 7/8" (22.2mm) hole an d install
a box connector through, into the junction box. Snap the box con nector clamp onto the supply wires.
D. Using the wire connectors, connect the ground green wires (G), the common white wires (N)
together, then the hot black wires (L) and then the refer to Figure 3.
E. Reinstall the cover plate using the three screws, as shown in Figure 1.
Operation
Read and understand this entire owner’s manual, including all safety information,before
plugging in or using this product. Failure to do so could result in electric shock, fire, serious
injury, or death.
Figure ( H )