User`s guide

CClleeaann tthhee pprriinntt hheeaadd

Frequency: on each ribbon change and after each cleaning cycle of the card feed module

Maintenance accessory: cotton swab saturated with isopropyl alcohol

The print head is cleaned at the time the inside of the printer is cleaned (see above).

However, in order to preserve the original printing quality and to reduce the incidents created by the

presenc

e of surplus ink on the surface of the print head, it is recommended that the print head be clea-

ned regularly (at each ribbon change) using the cotton swabs supplied with the UltraClean cleaning kit.

It is very important to protect the print head and any other related component handled

against any electrostatic discharge.

The print head is a fragile component of your printer. To prevent any damage to it:

■

Before cleaning the print head, disconnect the printer from its power supply.

■

Comply with the cleaning cycles.

■

Never put the print head into contact with pointed and or metal objects.

■

Avoid direct contact between the surface of the print head and the fingers. This could result in

an altered print quality, or even permanent damage to the print head.

3. Clean the roller with a cleaning cloth from your

cleaning kit. Eliminate all dust by rubbing the

cloth lightly over the entire surface of the roller.

7. Clean the roller with the

cleaning cloth & put the feeder

back into place until il clicks.

8. The printer is again available

for use.

hen it is dry, replace the

roller into the printer, making

ure it is properly

positioned.

5. Put the ribbon

back in its place,

lower and close

the cover.

6. Remove the

feeder as

indicated.

After a cleaning cycle, wait 2 minutes for the cleaning fluid to evaporate completely

before using the printer