User`s guide

Following a cleaning cycle, wait 2 minutes until all the cleaner is completely evaporated
b
efore using the printer.
Take advantage of this interruption to clean the print head (see below).
R
R
e
e
c
c
o
o
m
m
m
m
e
e
n
n
d
d
a
a
t
t
i
i
o
o
n
n
s
s
Maintenance of the card feed module ensures a high quality of printing. Evolis recommends
that you perform servicing on each ribbon change. Without waiting for the signal of the light
of the printer, proceed as described above.
27
SSeerrvviiccee tthhee cclleeaanniinngg rroolllleerrss
The function of the cleaning rollers is to eliminate any residual dust of the cards before they enter
the feeder system.
This roller, therefore systematically becomes dirty. This is a sign of its efficacy.
If this roller remains clean, we suggest that you check its quality by contacting your Evolis dealer in
order to replace it, if applicable.
To supplement the servicing of the card feeder system which is intended to clean it, you can obtain
a satur
ated cleaning cloth and clean this component thoroughly.
Frequency: on each ribbon change and after each cleaning cycle of the card feed module
Maintenance accessory: cleaning cloths
Proceed as follows:
1. Open the c
over.
If there is one,
remove the ribbon
and l
ocate the
cleaning roller.
2. Release the cleaning
r
oll
er from its seat.