User`s guide

12
IInnssttaallll tthhee ccaarrddss
TTyyppeess ooff ccaarrddss
T
attoo supports PVC cards varying in thickness between 0.25 mm (10 mil) and 0.76 mm (30 mil).
F
or optimum quality, these cards must comply with CR Standard 80.
10 mil cards must be used only for monochrome printings
There are several feeding and ejection modes available.
The driver must be set up accordingly to your needs and choice
(cf Chapter 2)
IInnssttaallllaattiioonn iinn tthhee ffeeeeddeerr
The cards are installed in the feeder as follows:
2. Insert the
cards into the
f
eeder as
indicated,
printable face
do
wn.
3. Put the feeder
back int
o plac
e
in the printer
until it “Clicks”
in place.
1. Remove the
feeder as
indic
ated.
Only use the type of cards appearing
in the Technical Specifications in this
manual
Do not touch the printable surface of
the cards: the printing quality depends
on this.
Do not use cards that are damaged,
bent or that have an embossed texture.
Always store the blank cards in a
clean and dust-free location.
To load a card manually from the feeding mouth :
Insert a c
ard in the feeding mouth.
The card will be automatically taken in and
ejected after the printing process.