User`s guide

Installation of the interface cable
and power supply
If you wish to use your Pebble printer with the USB port, install the Windows driver before connecting
this port.
1. Connect the interface cable supplied with your printer as indicated in the following
2. Connect the other end of the cable to the corresponding port on your computer
3. Connect the cable from supply to supply and then connect the power cable to the printer.
4. Then connect the end of the power supply cable to an earthed socket
5. The printer is under power. The light on the control panel comes on and the print head rises and
falls to indicate the correct mechanical working of the printer. If the light fails to come on, this means
that the installation has not been carried out correctly or possibly that the printer is not working pro-
perly. Check the installation.
Stand by
The Pebble printer may be left in stand-by at any time by pressing the push button as indi-
cated. The green light on the push button goes out.
To reactivate the printer, press the push button for one second. The green light on the
push button comes on.
The printer automatically goes into stand-by after 10 minutes of inactivity.
8
Turn off the printer by pulling the
plug out of the socket, which must
always be accessible.
This product must be connected to
an electrical installation that is cor-
rectly protected and grounded.
FI: "Laite on liitettävä suojamaa-
doitus koskettimilla varustettuun
pistorasiaan"
NO: "Apparatet må tilkoples jor-
det stikkontakt"
SE: "Apparaten skall anslutas till
jordat uttag"
This product is also designed for IT
power distribution system with
phase-to-phase voltage 230V.
Power
Parallel