User`s guide

39
Appendix B
Smart Card Contact Station
Introduction
Pebble printers with a Smart Card Contact Station are called Pebble Smart printers. The working mode
of a Pebble Smart printer is identical to that of a Pebble printer.
The Smart Card Contact Station of the Pebble Smart enables the chips to be programed to the ISO
7816-2 standards.
Location of the Contact Station
The Contact Station is a module installed in the factory on Pebble Smart printers.
The Contact Station is positioned over the path of the cards and before the print head.
To contact the Station, the chip card is placed under it and is pushed up.
The programming sequence of a chip is always carried out before
the card is printed.
Only use chip cards conform to ISO 7816-2.
Never print on the chip.
Card orientation
Chip cards must be installed in the card feeder so that the chip is downwards, as shown below:
max.max.
CLIC
1. Remove the feeder
from the printer as
shown.
2. Lower the spring system as
shown and insert 100 chip
cards of 0.76 mm (30mil) at
most (chip downwards).
3. Put the feeder back in the
printer. Then press on the top
of the feeder until it clicks.
max.max.