User`s guide

Stage 3 - Installation of the new printing head

1. Make sure that the printer is turned on and connected to a computer where the printing pilot has

been installed.

2. Click on the “Tools” dialogue box In the printing pilot properties.

3. In the part “Converse with printer” enter the following : Pkn;x

x = the kit number of the printing head on a transparent label on the printing head

Example : if the kit number of the printing head is: 179-004-00048, the following command

must be entered: Pkn;179-004-00048

If the printing head kit number has not been correctly entered, it may cause the printer to mal-

function.

Two leds flash simultaneously on the printer control panel. They indicate that the printer inter-

ior needs cleaning. No printing operation may be started until this is done.

See

chapter 3 Maintenance - Cleaning the inside of the printer to clean when a head has been chan-

ged. At the end of the cleaning cycle,

check the cleaning roller then reinstall the ribbon and the

cards. Your Evolis printer is ready to personalise your cards once more.

Stage 2 – Installation of the new printing head

2. Insert the head vertically on

the two guides

3. Turn the printing head to

“clip” it in the metal part.

4. Close the cover of the printer.

The printing head is now

installed.

1. Take the new

printing head and

insert the cable/s in

its/their housing.