User`s guide

Following a cleaning cycle, wait two minutes for the cleaner to evaporate completely before

using the printer again.

Although the cleaning alert might have been triggered, the printer will continue to work.

It is also possible to trigger a cleaning sequence without waiting for the signal of the light of

the printer. This is carried out by pressing the push button of the Control Panel for a few

seconds.

In this case, first repeat all the operations described above.

Maintaining the print head

Cleaning cycle: on each ribbon change

Use: cleaning swabs

The cleaning head is cleaned when cleaning the interior of the printer (see preceding section). However,

in order to preserve the original printing quality and reduce the incidents caused by an excessive pre-

sence of ink on the surface of the print head, it is recommended that you clean it regularly (every 1000

cards) using the cleaning swabs provided with the UltraClean cleaning set.

It is very important to protect the print head and all other associated components from any

electrostatic discharge. The print head is a fragile element. To avoid damaging it :

■ Before cleaning the print head, disconnect the printer from the mains.

■ Respect the cleaning cycles

■ Never place the print head in contact with sharp of metal object.

■ Avoid direct contact of the surface of the print head with fingers. Changed pint quality

or even permanent degradation of the print head could result.

1. Take a new swab

and press on the

stick to let the

liquid out.

Following a cleaning cycle, wait two minutes for the cleaner to evaporate completely before

using the printer again.

2. Open the printer cover

and locate the print head.

Then, gently rub the

swab along over the print

head for several seconds.