User`s guide

11
Installing the manual feed tray and loading the cards
The Pebble printer may be optionally fitted with a manual supply tray for inserting cards one by one.
Manual card feeder option should be set through the driver Properties. In the Tools tab click
on Dialog box button. Then select Manual feed option in Source Tray menu and in Output
Tray menu choose the option according to the required operation mode for the card exit.
`Click on the Set button to confirm.
The manual supply tray is installed as follows:
2. Using the lever, adjust the thickness
of the card to MAX.
1. Remove the feeder from
the printer as shown.
3. Place the manual supply tray in the printer as
indicated. Then press on the top of the tray
until it clicks.
Adjusting the card thickness
The Pebble printer is fitted with a manual adjustment system for the thickness of the cards that is acces-
sible either from inside the printer or when the cover is open.
Pebble printers accept card thickness from 0.25 mm (10mil) to 1 mm (40mil).
Factory setting for card thickness is 0.76 mm (30mil).
CLIC
4. Insert the card as shown.