User`s guide

Installation of the interface
and supply cables
WARNING !
Make sure that the printer switch is at 0 (OFF).
1. Connect the interface cable supplied with your printer as shown above.
2. Connect the other end of the cable to the corresponding port of your computer.
3. Connect the supply cable to the supply and then connect the connector of the supply cable
to the printer.
4. Then connect the end of the supply cable to an earthed mains socket.
5. Turn on the printer.
The green LED’s from the control panel lights and the print head rises and falls, indicating that the
mechanical operation of the printer is correct.
If the green LED’s fails to light, this means that the installation has not been carried out correctly or
even that the operation of the printer is faulty. Check the installation.
IMPORTANT !
This product is turned off by disconnecting it from the mains, which must remain accessible.
This product must be connected to an electrical installation that is correctly protected and
earthed.
FI: "Laite on liitettävä suojamaadoitus koskettimilla varustettuun pistorasiaan"
NO: "Apparatet må tilkoples jordet stikkontakt"
SE: "Apparaten skall anslutas till jordat uttag"
7