User`s guide

36
Annexe B
Smart Card Contact Station
Introduction
The Dualys printers with a Smart Card Contact Station are called Dualys Smart printers. The working
mode of a Dualys Smart printer is identical to that of a Dualys printer.
The Smart Card Contact Station of the Dualys Smart enables the chips to be programmed according
to ISO 7816-2 standards.
Location of the contact station
The Contact Station is a module installed in factory on Dualys Smart printers.
The Contact Station is placed over the route of the cards and after the print
head. To come into contact with the station, the chip card is placed under it
and is pushed up mechanically.
NOTE !
The programming sequence of a chip is still carried out
before the card is printed.
IMPORTANT !
Only use chip cards in line with the ISO 7816-2 standard.
Never print on the chip.
Orientation of the cards
The chip cards must be installed in the card feeder in such a way that the chip faces down as shown below:
max.
max.
max.
max.
1. Remove the feeder from
the printer as shown.
2. Press the spring system down
inside the feeder and insert the
cards as shown (100 cards max.
0.76mm – 30mil).
3. Replace the feeder in the printer.
Then, push on the upper part of
the feeder until you hear a “click”.
CLIC