User`s guide

Correcting card jamming

In the printing station:

Remove the card as follows:

1. Open the printer cover and remove the ribbon.

2. Remove the card by pushing it manually towards the printer outlet. In the presence of several cards,

push the top one first.

3. Refit the ribbon and close the printer cover.

4. Press the push button on the control panel.

In the flip over module:

Remove the card as follows:

1. Turn off the printer

(position 0) and remove

the card feeder from the

printer.

2. Open the flip over

module door as shown.

3. Remove the card from

the flip over by turning the

flip if necessary. Close the

flip over module door.

To prevent card jamming:

1. Make sure that the thickness of the card used corresponds to the specifications in the

“Technical Specifications” chapter of this manual.

2. Make sure that the cards are not swollen.

3. Make sure that the cards are not stuck together.

4. Replace the feeder in the printer.

Then, push on the upper part of the

feeder until you hear a “click”.

CLIC