User`s guide

Status of the LED’s Interpretation Solution or explanation
MECHANICAL PROBLEM
■
There is jamming on the card in the printing
station or in the flip over module
■
A mechanical part is faulty in the printer.
Press the push button for one second. If the
problem persists, call your Evolis Reseller for
assistance.
MAGNETIC ENCODING
■
The orientation of the magnetic track in the
ERROR OR feeder is not correct
PRINTER COVER OPEN
■
The type of encoding is not correctly set
(HICO or LOCO). See annexe A of this
manual for information.
■
The encoded data are not conform with the
ISO 7811 standards or are not conform with
the parameters predefined in the properties of
the driver. See annexe A of this manual for
information.
Press the push button for one second.
The printer restarts the magnetic encoding
cycle three times with the same card and if
the problem still occurs the same, it tries
with two new cards. If the problem persists,
call your Evolis Reseller for assistance.
■
The printer cover is open. Close the cover.
The activity in course restarts.
COOL DOWN MODE
■
The printer head cooling system is active.
The printer stops working after a few seconds.
When the print head has returned to its normal
working temperature, the activity is restarted.
24