User`s guide

NOTE!

Although the cleaning signal has been activated, the printer will continue to work.

It is also possible to start a cleaning sequence without waiting for the cleaning signal

of the printer. This action is carried out by pressing the push button from the Control

Panel for few seconds. In this case, repeat all the operations above.

Cleaning of the print head

Use: cleaning swabs

Cleaning cycle: each time you load a new ribbon

The print head is cleaned when cleaning the interior of the printer (see preceding section). However,

in order to preserve the original printing quality and reduce the incidents caused by an excessive

presence of ink on the surface of the print head, it is recommended that you clean it regularly using

the cleaning swabs provided with the UltraClean cleaning kit.

ATTENTION !

It is very important to protect the print head and all other associated components from any

electrostatic discharge.

The print head is a fragile element. To avoid damaging it:

■

Before cleaning the print head, disconnect the printer from the mains.

■

Respect the cleaning cycles

■

Never place the print head in contact with sharp of metal object.

■

Avoid direct contact of the surface of the print head with fingers. Changed print quality

or even permanent degradation of the print head could result.

To clean the print head, proceed as follows:

3. Switch the

printer off.

Then, gently rub

the swab along

the print head for

a few seconds.

1. Take a new swab

and press on the stick

to let the liquid out.

2. Open the

printer cover

and locate the

print head.

IMPORTANT !

Following a cleaning cycle, wait 2 minutes for the cleaner to evaporate entirely before using

the printer.