User`s guide

WARNING !
If the cleaning cycle is not performed before the 1200th card is printed, the print
head warranty is void.
This simple cleaning system requires the use of pre-saturated cleaning cards specially conceived for
the printer. A cleaning kit including card samples is delivered with your package. The repeated passes
of the card inside the printer clean the card transport rollers, the cleaning rollers and the print head.
To clean the interior of the printer, proceed as follows:
19
1. Remove the feeder
from the printer as shown.
4. Check
that the card
thickness is set to
0.76 mm (30 mil).
5. Replace
the feeder in
the printer.
2. Remove the cards
present in the feeder.
3. Take a new pre-saturated
cleaning card and insert it
in the feeder as shown.
8. Press the control panel push but-
ton for a few seconds.
The cleaning starts.
Note: the used cleaning card is
ejected in the reject card box.
6. Remove the ribbon
from the printer.
7. Close the
printer cover.
IMPORTANT !
After performing a cleaning cycle, wait 2 minutes for the cleaning fluid to
evaporate completely before using the printer again.
CLIC