User`s guide

10
Card thickness adjustment
The Dualys printer is fitted with a manual card thickness adjustment system which is situated in the
feeder cage.
1. Locate the door of
the output hopper.
2. Open the door as
shown and remove
the printed cards.
3. Close the door.
2. Move left or right the
handle as shown to adjust
the card thickness.
NOTE !
The Dualys printer accepts card thichness from 0,25 mm (10mil) to 1 mm (40mil).
Factory setting for card thickness is 0.76mm (30mil).
1. Remove the feeder from the
printer as shown.
3. Replace the feeder in the printer.
Then, push on the upper part of the
feeder until you hear a “click”.
CLIC
Card output hopper
The Dualys printer is equipped with an output hopper with a capacity of 100 cards (0.76 mm – 30mil)
devoted to receiving the printed cards.