User`s guide

Loading the cards

Card feeder

The Dualys is equipped with a card feeder that contains up to 100 cards (0.76mm – 30mil).

IMPORTANT !

Card thickness:

• The Dualys accepts card thickness from 0.25mm (10mil) to 1mm (40mil).

Advice concerning the selection of cards:

• Only use the type of cards appearing on the Technical Specifiactions chapter of this manual

• Do not touch the printable surface of the cards ; the printing quality depends on this

• Do not use damaged or folded cards or with a texture in relief

• Always stock blank cards in a clean, dust-free loaction

2. Press the spring system down inside the

feeder and insert the cards as shown.

Note: The side to be printed must be

facing down.

1. Remove the feeder from the

printer as shown.

3. Replace the feeder in the printer.

Then, push on the upper part of the

feeder until you hear a “click”.

CLIC

max.max.max.