User`s guide

47
SSmmaarrtt CCaarrdd CCoonnttaacctt SSttaattiioonn
Pebble and Dualys printers with a Smart Card Contact Station are called Pebble Smart and Dualys
Smart printers. The working mode of a Pebble and Dualys Smart printers is identical to that of a
Pebble and Dualys printers. The Smart Card Contact Station of the Pebble Smart or Dualys Smart
enables the chips to be programmed to the ISO 7816-2 standards.
LLooccaattiioonn ooff tthhee ccoonnttaacctt ssttaattiioonn
The Contact Station is a module installed in the factory on
Pebble and Dualys Smart printers.
The Contact Station is positioned over the path of the cards and
before the print head. To contact the Station, the chip card is
placed under it and is pushed up.
The programming sequence of a chip is always car-
ried out before the card is printed.
Only use chip cards conform to ISO 7816-2.
Never print on the chip.
CCaarrdd oorriieennttaattiioonn
Chip cards must be installed in the card feeder so that the chip is downwards, as shown below:
2. Lower the spring
system as shown
and insert 100
chip cards of 0.76
mm (30mil) at
most (chip
downwards).
1. Remove the
feeder from the
printer as
shown.
3. Put the feeder back in
the printer. Then press
on the top of the feeder
until it clicks.