User`s guide

MMaaggnneettiicc eennccooddiinngg
P
ebble and Dualys printers with a magnetic stripe card encoder are called Pebble Mag and Dualys Mag printers.
The operating mode of a Pebble and Dualys Mag printer is identical to that of a Pebble or Dualys printer.
The magnetic encoder encodes tracks ISO 1, 2 and 3 in a single passage and then checks the data.
Set in high coercivity (HICO) or in low coercivity (LOCO) with a simple click from the Windows driver,
however, the encoders of the Pebble and Dualys Mag are sent adjusted to high coercivity (HICO) by
default, unless specifically requested on the order.
LLooccaattiioonn ooff tthhee mmaaggnneettiicc eennccooddeerr
The magnetic encoder is a module installed in the factory on
Pebble and Dualys Mag printers. The writing and reading head
is placed under the path of the cards and after the print head.
The encoding sequence of a card is still carried out
before printing.
Only use cards with magnetic tracks conform to ISO
7810 and ISO 7811. To work properly, the magnetic
track must be moulded in the card. Never use a card
with a glued magnetic track.
CCaarrdd oorriieennttaattiioonn
Cards with a magnetic track must be installed in the feeder so the magnetic strip faces upwards, as
follows:
SSeettttiinngg tthhee WWiinnddoowwss DDrriivveerr
When first installing the Windows driver, it is necessary to parameterise the functions of the magne-
tic encoder. The functions of the magnetic encoder are accessible from the Tools dialog box of the
driver by clicking the Encoding Definition button.
45
2. Lower the spring
system as shown
and insert 100
magnetic cards of
0.76 mm (30mil) at
most.
1. Remove the
feeder from the
printer as
shown.
3. Put the feeder back in
the printer. Then press
on the top of the feeder
until it clicks.